The high Efficiency concentrator machine is suitable for dehydrating water of the concentration and gangue in the concentrating factory, making the mash of 20%~30% raise up to 40%~70%. It is widely used for melting, chemical, coal, non metal concentration, environment...<br /><a class="read-more-button" href="http://poecompetition.com/characteristic-and-installation-of-concentrator/">Read more</a>
The high Efficiency concentrator machine is suitable for dehydrating water of the concentration and gangue in the concentrating factory, making the mash of 20%~30% raise up to 40%~70%. It is widely used for melting, chemical, coal, non metal concentration, environment protection etc industry.
High efficiency concentrator machine is not only a settlement and a new type dehydrating equipment of combining the mash percolate.
Characteristics:1. Adding flocculating agent, bigger the diameter of the deposit solid grain, speed up the deposit.2. Set the lean board, reducer the mash deposit distance, increase the deposit and square.3. Have effect on flocculating. Percolating, compressing and dealing quantity of the slurry deposits.4. Fit the perfect automatic facility.
Manufacturing:1. In the manufacturing various parts, components, should according to the technical requirements of the drawing, and adopt drawing the proposed materials for manufacturing, need to be modified by the designers to agree.2. The welding parts after welding must go through detailed in check seam are good, especially 6 type let slot section (figure 4 P. 304) welding landlords should pay attention to more, and in close degree examination as after completion, filling liquid shall not have after dripping phenomenon. Welding let slot to pick up let slot require the use of T424 electrode welding rake should keep drawing is in the correct position.3. The signal pressure installations in the spring, in the system after the pressure test. When spring compression deforms of 10 mm, 6 types by concentrating machine of the axial pressure should be 1025 kg. 12 types by concentrating machine of the axial pressure should be 2250 kg.
Installation:1. The installation transmission and slow components should be special attention to keep parts processing of the face clean. Turn a contact part before installation application kerosene to wash, and in the installation and lubricating oil, during the installation process should carry on the individual parts and components of transmission inspection. Turn not to have noise and turn the phenomenon such as difficult.2. Always the installation process from the first part of the installation, respectively, then install the transmission part of the base parts and driving part, finally installed the rest parts.
Stone production line : conveyor : dryer : crushing station : plant :